Repair & Restoration

One of yesterday's little jobs was to tidy the outhouse at the South East end of the cottage.  This is referred to, in these parts, as the freezer room for rather obvious reasons.

During the clear out/tidy up I retrieved a rather nice brass reading lamp that had stopped working many years ago. I took it in to the workshop and discovered that it was a simple blown fuse. We now have a rather nice working lamp that is covered with a decades worth of grime, at least!

Our new freezer was delivered this morning* and had to stand for twenty four hours before being switched on. This left me plenty of time this morning to grab the Brasso and clean up the filthy, tarnished lamp. It does look rather splendid now, and we just need a new shade and bulb to finish off the job.

There was a second delivery this morning. The polycarbonate, greenhouse glazing panels have arrived.** And, as the morning warmed up I headed out in to the workshop, grabbed a pair of sawhorses and a few tools and headed over to the greenhouse.

Stage one of my greenhouse restoration was to replace the panels at the bottom of the pair of sliding doors.  I soon had the first door slid out of its track and resting on the pair of sawhorses. Replacing the fibre board panel was actually quite straightforward and I had finished both doors shortly after lunch.

The afternoon saw a brisk walk around the Three Miler with the dogs and I was looking forward to a lazy evening when my phone beeped at me ... Shit! I'd forgotten that I had a Tai Chi class this evening.

---

* I was delighted to see that the delivery van was decorated with the obligatory cock and balls scrawled in the grime on the rear door.

** We have a rather nice Robinson Greenhouse in the garden, but after many years it needs a little attention to keep it at its best.  The ground level "panes" are not glass, but panels of a cement fibre board. These have deteriorated over the years and are now brittle and crumbling. What used to be a weather and rodent proof greenhouse now has gaping holes where the fibre board has fallen apart.  I have purchased some 4mm polycarbonate glazing panels and these will be used to fabricate the replacement panels.